 |
After it cools, sand the end square and flat if necessary.
Click the image for a larger view. |
 |
Weld the solid steering shaft to the yoke, centered under the bolt hole, with the flat of the shaft parallel with the bolt. The shaft has to be square with the bolt.
Click the image for a larger view. |
 |
Install the prepared nut in the end of the steering tube.
Click the image for a larger view. |
 |
Weld all around.
Click the image for a larger view. |
 |
Weld the 8" tube, and the 13" tube together at 90 degrees with the holes in the bar to the inside if the L. Set it with a square, and clamp tightly so there is no twist when welding.
Click the image for a larger view. |
| Next Page |
