Cowl top support
Select messages from
# through # FAQ
[/[Print]\]

Rodding Roundtable -> Tech Archive

#1: Cowl top support Author: Charlie Chops 1940Location: Muskegon, MI PostPosted: Tue, Mar 06 2007, 9:17 pm
    —
I have a brass Duval windshield for my '32 roadster. After I got it fit to the cowl I found that I could make it flex the sheet metal in the center. So I made up a backer to go under the center. I made it out of 16ga and broke over the outside edges. Since I'm always looking for something under there to tie wires or something to, I drilled the edges with a bunch of 1/4" holes.

I then drilled a series of 1/8" holes in the top of the cowl and bolted the backer in place. The rear of it went between the body skin and a stock stiffener at the back edge.

I then rosette welded the backer to the skin, and then ground the welds smooth. It worked - no more flex.

#2:  Author: enjenjoLocation: Swanton, Ohio PostPosted: Mon, Mar 12 2007, 6:52 pm
    —
I like the idea of a place to hang wires and so forth. I may use that even without a Duvall windshield.

When I am filling a firewall, on the holes that originally hald the insulation in place, instead of just welding them shut, I weld a 1/4" by 1 1/2" elevator bolt behind the hole. This gives you a way to hang the AC evaporator, firewall insulation, wires, and other things.

#3:  Author: Charlie Chops 1940Location: Muskegon, MI PostPosted: Mon, Mar 12 2007, 7:57 pm
    —
I did that on the firewall of my late (as in don't have it anymore) '55 Nomad.

Charlie



Rodding Roundtable -> Tech Archive


output generated using printer-friendly topic mod. All times are GMT - 5 Hours

Page 1 of 1

Powered by phpBB © 2001, 2005 phpBB Group